Raptor C-35

18 kVA Multifunctional Primary Test System

The Raptor C-35 features the entire functionality of the C-05 and supplies 18 kVA power for cases where the distance to the tested object cannot be reduced. 

This setup can comfortably sustain current values above 8000 A when cables with the appropriate section are used. 

This configuration is for applications where the High Current injection values are high enough to require even more power (compliance voltage) 

to reach the desired current in the test object, which usually requires long cables. 

Using this configuration instead of the C-25 will avoid the need to wind turns on it to be able to reach a distant load, achieving higher currents. 

Each RAPTOR SL unit added to the system makes for almost twice the power of the MASTER. 

This configuration is sufficient adequate for injection of very high current levels (>8000 A) into loads situated close in distance (around 1 meter) of the test set, 

using of course, cables with the required cross section. 

Low voltage CB up to a nominal of 1500 A can be properly tested. 

▶Permanent Max Current: 3,800 A / 18.4 kVA 

▶3 Minutes Max Current: 7,500 A / 28 kVA 

▶3 Seconds Max Current: 15,000 A / 22 kVA 

▶Compliance Voltage Range: 6.00 to 1.48 V

The Raptor C-35 composed by:

 - One Raptor MS Master Unit,

 - One Raptor HH Control Console,

 - Three Raptor SL Slave Units,

 - One Set of Standard Accessories